How to use DSPTune.PRO

From the download to a saved tune, step by step.

  1. Get the program

    DSPTune.PRO is in a closed pilot. Leave your email and we will write when your slot opens. Then download and install DSPTune.PRO on your Windows 10 or 11 laptop.

    Join the pilot
  2. Sign in

    Open it and choose Sign in with browser. An account (it costs nothing) opens your DSP’s map, the demo and DSPTune Weave Core; Pro and Leya AI need a Pro plan.

  3. Plug in the DSP and the microphone

    A USB cable to the DSP, with the maker’s own program closed. Best: a USB sound card with a loopback, its output into a DSP input and a measurement microphone on its input. No sound card: the laptop’s audio output into the DSP’s analog input and a USB measurement microphone like a UMIK, with its calibration file. Built-in laptop microphones are refused.

  4. Set up the speakers

    On Outputs, open Speaker setup and say which speaker each output drives. Outputs with the same name are one speaker.

  5. Run DSPTune Weave

    Choose the target (SQ, Daily or Flat), Core or Pro and where the microphone goes. One window shows every output and its speaker: press Start. Keep the engine running. It writes as it goes and asks only when it needs you: Retry, Skip this output or Stop.

  6. Check the result

    Proof measures again; you see before and after and choose Keep or Put back. Put back undoes exactly what DSPTune Weave wrote.

  7. Listen and adjust

    Tell Leya what you hear, in your own words. What you ask her for applies at once with Done and Undo; her own ideas wait for Apply. Leya AI is included in Pro and Ultra.

  8. Save

    Nothing is stored as a preset until you press Save. On a connected DSP, File > Save writes the setup file and the DSP’s memory.

What each step measures: How it works